Practice Experience of Manufacturing Department
Release time:
2023-03-21
As a staff member of Huang Ping Peak Marketing Department, I learned the production process and product shipment in the manufacturing department last August, which was divided into three stages.
Phase I: The Environmental Security Department organized us to carry out cross-departmental transfer safety learning, and the Manufacturing Department conducted production safety education and learning. Safety education was carried out on the illegal phenomena and safety accidents that often occur at the operation site, which made me understand the prevention knowledge of safety accidents, cases such as occupational injury factors and on-site safety operation requirements. I should dress strictly according to the production requirements.
Phase II: Be familiar with the performance and process of each equipment and understand the role of relevant raw materials in production during equipment maintenance. During the kiln ignition production, I followed the shift to understand the actual production, which links and deviations have an impact on the quality of clinker and cement and the corresponding emergency treatment measures. For example, in the process of cement clinker production, limestone, sandstone, leaf rock, clay, iron and other raw materials are required according to the batching requirements. After being measured by belt weighing, preliminary detection and feedback are carried out through cross-belt online analyzer to the measuring scale for dynamic fine adjustment, they enter the raw material roller for grinding according to the control standard, providing the basis for kiln calcination. After metering, the raw coal enters the coal vertical mill for grinding, and the quality control requirements of the mill are adjusted in time according to the characteristics of the coal and the calcination of the kiln, so as to facilitate the calcination of the kiln. In addition, the raw meal homogenized in the raw meal homogenization warehouse is metered and transported to the preheater for step-by-step preheating, decomposition and collection into the kiln. The decomposed material undergoes calcination in the rotary kiln to form qualified clinker and then enters the grate cooler for cooling. The key to cooling is to ensure that the quality of the clinker does not change, and once again the waste heat recovery and utilization. The cooled clinker is stored in the clinker warehouse to prepare for cement grinding. This is the clinker production process in the two grinding a burning. And cement grinding is cement manufacturing cement grinding is the final process of cement manufacturing, but also the most power consumption process. The production process for the cement clinker, desulfurization gypsum, grinding aids, fly ash, coal gangue and other materials according to the requirements of the measurement with grinding products to meet the market demand, the main control indicators are fineness, specific surface area, setting time, strength and so on.
Phase III: Cement delivery is also divided into three points. The first is to understand the significance of cement multi-point alternate feeding, the second is to be familiar with the cement delivery process, cement coding and spray code control, and finally to understand the work flow and function of production equipment.
After the 24-day production practice, I have a deeper understanding of the basic knowledge of cement production. Through the practical study of the technological process and mechanical equipment of the new dry cement production, I am more familiar with the characteristics and quality advantages of the products. This internship is to improve my comprehensive ability, strengthen my understanding of quality, improve the ability to work, but also understand the production will be applied to the new process, new technology, new equipment. At the same time to improve and strengthen the sense of teamwork, collaboration is the basis for the successful completion of the work. (Le Chao Chao)
More information
Create a safe environment to meet the G20
The G20 summit will be held in Hangzhou from September 4 to 5. On August 8, the safety committee of the group company will hold a meeting to make arrangements and put forward requirements for the key work of safety and environmental protection from now to the summit. At the meeting, Chen Tianci, director of the safety management office of the group company, conveyed the requirements of the provincial, municipal and district governments during the G20 summit. Combined with the specific situation and work characteristics of each enterprise, he put forward requirements for environmental protection, safety, public security and other work. In terms of environmental protection management, we must strictly implement the company's environmental protection system, focusing on the management and disposal of solid waste, and the emission control of sewage and dust; at present, in the high temperature season, we must focus on strengthening fire safety management, especially warehousing and hazardous chemical business units., We must strictly do a good job in daily safety inspections; all enterprises must promptly convey the relevant spirit of their superiors to each employee, strengthen ideological and political work, and create a good and harmonious corporate atmosphere. Xiang Chongping, deputy general manager of the group company, supplemented the territorial management of related matters of various enterprises, properly handling internal contradictions, and strengthening network security management. Yu Jianhong, general manager of the group company, stressed at the meeting that safety and environmental protection work should be talked about and grasped every day, and should not be relaxed at any time. Safety accidents seem to be accidental, but in fact they are inevitable, and their roots lie in the usual violations and carelessness. Therefore, all enterprises should seriously organize their employees to carry out self-examination and self-correction, effectively improve their safety awareness, and find out and rectify the small problems and hidden dangers that have been ignored in their work in the past. At the same time, it is necessary to do a good job in the safety zone of operation and the protection of related facilities, through advanced control systems, safe facilities and equipment, standardized
2020
07-31
Create a safe environment to meet the G20
The G20 summit will be held in Hangzhou from September 4 to 5. On August 8, the safety committee of the group company will hold a meeting to make arrangements and put forward requirements for the key work of safety and environmental protection from now to the summit. At the meeting, Chen Tianci, director of the safety management office of the group company, conveyed the requirements of the provincial, municipal and district governments during the G20 summit. Combined with the specific situation and work characteristics of each enterprise, he put forward requirements for environmental protection, safety, public security and other work. In terms of environmental protection management, we must strictly implement the company's environmental protection system, focusing on the management and disposal of solid waste, and the emission control of sewage and dust; at present, in the high temperature season, we must focus on strengthening fire safety management, especially warehousing and hazardous chemical business units., We must strictly do a good job in daily safety inspections; all enterprises must promptly convey the relevant spirit of their superiors to each employee, strengthen ideological and political work, and create a good and harmonious corporate atmosphere. Xiang Chongping, deputy general manager of the group company, supplemented the territorial management of related matters of various enterprises, properly handling internal contradictions, and strengthening network security management. Yu Jianhong, general manager of the group company, stressed at the meeting that safety and environmental protection work should be talked about and grasped every day, and should not be relaxed at any time. Safety accidents seem to be accidental, but in fact they are inevitable, and their roots lie in the usual violations and carelessness. Therefore, all enterprises should seriously organize their employees to carry out self-examination and self-correction, effectively improve their safety awareness, and find out and rectify the small problems and hidden dangers that have been ignored in their work in the past. At the same time, it is necessary to do a good job in the safety zone of operation and the protection of related facilities, through advanced control systems, safe facilities and equipment, standardized
2020
07-30
Technological Innovation Brings Enterprises to the International Stage
Editor's note: As a 17-year-old senior enterprise in the extract industry, Tianjin Jianfeng Natural Products Research and Development Company has devoted more time, energy and funds to R & D and innovation while doing a good job in business operations. It has always been an important direction for them to achieve self breakthrough by turning waste into treasure and technological innovation. Therefore, it has achieved the improvement of market popularity at home and abroad and the rapid growth of sales volume, and has become a key science and technology enterprise in Tianjin Binhai New Area. On July 9, the "Bohai Morning Post" "TEDA Technology Little Giant Tour" column published an exclusive interview, describing the growth experience and a series of achievements of Tianjin Jianfeng Natural Products Company. This article will be reproduced in this newspaper for readers. "Little grape seed" grows into a little giant of science and technology to solve the problem of pesticide residues in plant extracts. Technological innovation has enabled the enterprise to step onto the international stage based on independent innovation and development. Starting from the initial grape seed extraction process, it has gradually grown into the largest professional fruit extract manufacturer in China with dozens of plant extract products conforming to international strict standards and an annual productivity of 2000 tons, tianjin Jianfeng Natural Products Research and Development Co., Ltd. (hereinafter referred to as "Tianjin Jianfeng") has gone through a decade of rapid development. As a supplier of raw materials in health food, beverages, cosmetics, baked goods and many other fields, the concept of "truth and safety" advocated by Tianjin Jianfeng has run through all aspects of R & D and production. Its products are not only well-known in China, but also exported to Europe and the United States. Become a new business card of TEDA. Technological innovation is in line with international standards. "In people's lives, the beverages they drink, the health foods they eat, and the cosmetics they use will contain plant extracts.
2020
07-31
Create a safe environment to meet the G20
The G20 summit will be held in Hangzhou from September 4 to 5. On August 8, the safety committee of the group company will hold a meeting to make arrangements and put forward requirements for the key work of safety and environmental protection from now to the summit. At the meeting, Chen Tianci, director of the safety management office of the group company, conveyed the requirements of the provincial, municipal and district governments during the G20 summit. Combined with the specific situation and work characteristics of each enterprise, he put forward requirements for environmental protection, safety, public security and other work. In terms of environmental protection management, we must strictly implement the company's environmental protection system, focusing on the management and disposal of solid waste, and the emission control of sewage and dust; at present, in the high temperature season, we must focus on strengthening fire safety management, especially warehousing and hazardous chemical business units., We must strictly do a good job in daily safety inspections; all enterprises must promptly convey the relevant spirit of their superiors to each employee, strengthen ideological and political work, and create a good and harmonious corporate atmosphere. Xiang Chongping, deputy general manager of the group company, supplemented the territorial management of related matters of various enterprises, properly handling internal contradictions, and strengthening network security management. Yu Jianhong, general manager of the group company, stressed at the meeting that safety and environmental protection work should be talked about and grasped every day, and should not be relaxed at any time. Safety accidents seem to be accidental, but in fact they are inevitable, and their roots lie in the usual violations and carelessness. Therefore, all enterprises should seriously organize their employees to carry out self-examination and self-correction, effectively improve their safety awareness, and find out and rectify the small problems and hidden dangers that have been ignored in their work in the past. At the same time, it is necessary to do a good job in the safety zone of operation and the protection of related facilities, through advanced control systems, safe facilities and equipment, standardized
2020
07-31
The company requires each business segment to formulate medium-and long-term business plans.
According to our newspaper, "if an enterprise wants to develop in the long run, first of all, managers should have a long-term vision." On July 24, when general manager Yu Jianhong deployed the work for the second half of the year at the semi-annual meeting of the group company, he specifically asked all enterprises to formulate specific medium-and long-term business development plans for the next three to five years according to the industrial development trend and the group development strategy. Before making arrangements for the specific key work in the second half of the year, Yu Jianhong emphatically put forward the requirements for each business sector to formulate a business strategy plan for 2016-2018 according to the industry development trend and the group's development strategy. Yu Jianhong pointed out that the current group company's strategic decision-making and strategic development capabilities and efficiency still need to be improved. The publicity, understanding and implementation of the group's development strategy by various companies are not in place. The lack of medium and long-term business planning in each business sector restricts the business of the company. Development, cultivation of core products and profitability, construction of product brands, improvement of business scale and comprehensive strength. Last year, the group company asked the international trading company to formulate three-year work objectives and sign a three-year economic responsibility system with the company's management team. The actual effect shows that this has made the management team's management ideas clearer and more scientific and rational in terms of target setting, work arrangement and business development. For this reason, the group company put forward the requirements for the formulation of medium and long-term development plans for each business sector at this meeting. According to the industry characteristics of each business segment, market environment and other specific circumstances, the company makes requirements for the key content of the development plan of each business segment. For example, the pharmaceutical sector focuses on sales growth targets for key profitable products, product development and
2020
07-31
The company requires each business segment to formulate medium-and long-term business plans.
According to our newspaper, "if an enterprise wants to develop in the long run, first of all, managers should have a long-term vision." On July 24, when general manager Yu Jianhong deployed the work for the second half of the year at the semi-annual meeting of the group company, he specifically asked all enterprises to formulate specific medium-and long-term business development plans for the next three to five years according to the industrial development trend and the group development strategy. Before making arrangements for the specific key work in the second half of the year, Yu Jianhong emphatically put forward the requirements for each business sector to formulate a business strategy plan for 2016-2018 according to the industry development trend and the group's development strategy. Yu Jianhong pointed out that the current group company's strategic decision-making and strategic development capabilities and efficiency still need to be improved. The publicity, understanding and implementation of the group's development strategy by various companies are not in place. The lack of medium and long-term business planning in each business sector restricts the business of the company. Development, cultivation of core products and profitability, construction of product brands, improvement of business scale and comprehensive strength. Last year, the group company asked the international trading company to formulate three-year work objectives and sign a three-year economic responsibility system with the company's management team. The actual effect shows that this has made the management team's management ideas clearer and more scientific and rational in terms of target setting, work arrangement and business development. For this reason, the group company put forward the requirements for the formulation of medium and long-term development plans for each business sector at this meeting. According to the industry characteristics of each business segment, market environment and other specific circumstances, the company makes requirements for the key content of the development plan of each business segment. For example, the pharmaceutical sector focuses on sales growth targets for key profitable products, product development and
2020
07-31