News Center

Home page

Peak Report

News reports

Daye Peak Completed Two Equipment Reformation

Release time:

2022-04-06

News Recently, Daye Jianfeng Cement Company has reformed the loading belt structure of two packaging lines and the tail wheels of three reverse hoists for cement transportation.

Daye peak packaging system two packaging lines, due to the packaging machine is affected by external factors such as compressed air pressure, bag insertion position, cement specific gravity, paper bag size, etc., there will be different degrees of "flat bag " or horizontal bag, these cement bags pass through the unloading charter machine, bag cleaning machine, parallel belt bell mouth, chute, drum and other positions, if the whole package is not carried out in time, the package will be blocked. Cleaning the blocked package not only poses security risks, but also increases the workload of employees and causes waste of machinery and materials. In order to avoid the occurrence of bag blocking, special personnel should be assigned to carry out the whole bag work, so as to ensure that the cement bag can pass through each "gate " smoothly and the delivery is normal. The transformation of the packaging line structure has improved the guarantee coefficient of the normal operation of the packaging system, reduced the workload and safety risks of on-site employees, and also provided hardware guarantee for the optimization of packaging system personnel. The original plan to install the belt protection net was creatively replaced with the existing sealing shed, saving more than 10,000 yuan in production cost. Before the modification of the tail wheel of the

Daye peak cement warehouse reversing hoist, the pressure bar type counterweight box is mainly used to counterweight the top end of the tail of the warehouse reversing hoist. When the roller moves up and down, the counterweight box will also move, resulting in material leakage and dust generation due to lax sealing on the hoist side. Due to the generation of dust, the hoist bearing has been operating under high dust and high temperature for a long time, and the bearing seal is easy to wear, resulting in greatly shortening the service life of the bearing and increasing the consumption of machine materials. The bearing is built-in and difficult to find in time after damage. Moreover, however, the shutdown inspection affects the delivery efficiency.

After the transformation, the hoist adopts a fully sealed labyrinth dust-proof structure, the bottom bearing of the tail wheel is external, and the ejector rod is used to adjust the belt tension to reduce and avoid the movement of the counterweight box. Through technical renovation, the working environment at the bottom of the cement warehouse can be improved, the production dust can be avoided, the health of employees can be protected, the cleaning time of employees can be reduced, the efficiency of equipment maintenance can be improved, the service life of bearings can be prolonged, and the smooth delivery of cement can be ensured. Effectively solve the situation of leakage and ash of the tail wheel of the cement warehouse hoist and belt damage caused by belt deviation.

(Huang Bide Chen Cuihong)

More information

The Party committee of the company organized and studied the spirit of the Sixth Plenary Session of the 18th CPC Central Committee

The Sixth Plenary Session of the 18th Central Committee of the Communist Party of China was held in Beijing from October 24 to 27. It reviewed and approved the "Several Guidelines on Political Life within the Party under the New Situation" and the "Regulations on Inner-Party Supervision of the Communist Party of China. On November 22, the party committee of the group company successively held party committee and branch secretary meetings to learn the spirit of the sixth Plenary session of the 18th CPC Central Committee and put forward requirements for organizational construction and party member management. At the branch secretary meeting, Jiang Xiaomeng, secretary of the party committee of the group company, preached the main contents of "some guidelines on Inner-Party political Life under the New situation" and "regulations on Inner-Party Supervision of the Communist Party of China. He pointed out that seeking truth from facts, integrating theory with practice, keeping close ties with the masses, criticizing and self-criticism, democratic centralism, and strict party discipline are the basic norms and working principles of inner-party political life accumulated by the Communist Party of China for several generations. In the new social environment, some party members and cadres have bred some unhealthy atmosphere, which has damaged the image and interests of the party, the Sixth Plenary Session of the 18th Central Committee of the Communist Party of China proposed to strengthen and standardize the political life within the party, take the party constitution as the foundation, adhere to the party's political line, ideological line, organizational line and mass line, strive to enhance the political, contemporary, principled and fighting nature of the party's political life, and strive to enhance the party's ability of self purification, self improvement, self innovation and self improvement, Efforts should be made to improve the party's leadership and governance level, efforts should be made to safeguard the authority of the Party Central Committee, ensure the unity and unity of the party, maintain the advanced nature and purity of the party, and strive to form a centralized, democratic and disciplined party in the whole party

2020

07-31

Jinxi plant environmental protection facilities through the completion of acceptance

On November 1, Jianfeng Pharmaceutical Jinxi Pharmaceutical Factory successfully obtained the approval from Zhejiang Environmental Protection Department that the environmental protection facilities of the project passed the completion acceptance, and a key work of Jianfeng Pharmaceutical in 2016 came to an end. Jianfeng Pharmaceutical's annual output of 35 tons of cephalosporins, anti-tumor drugs and other raw material production lines and various preparation production lines technological transformation projects started construction in Jinxi Development Zone in October 2012 and were almost completed in September 2015. The construction of the project strictly abided by the "three simultaneous" system of environmental protection, conscientiously implemented the requirements in the environmental impact assessment report and its approval documents, and invested 19.34 million yuan in environmental protection facilities. The plant has basically realized the separation of clean and sewage. A new wastewater treatment system with a daily treatment capacity of 700 cubic meters and a "physical, chemical and biochemical" treatment process has been built, and an online monitoring device networked with the environmental protection department has been installed. All kinds of production wastewater, public works wastewater and domestic sewage are treated by the wastewater station and sent to Jinxi Sewage Treatment Plant for centralized treatment; there is an RTO regenerative incineration device of 10000 cubic meters per hour and a centralized treatment device of 4000 cubic meters per hour for chlorine-containing organic waste gas. All kinds of waste gas are discharged after collection and treatment. In October 2015, with the approval of Jinhua Economic and Technological Development Zone Branch of Jinhua Environmental Protection Bureau, the trial production of Jinxi project was carried out. After more than half a year of operation, in early July 2016, Zhejiang Environmental Monitoring Center Station carried out completion acceptance monitoring of environmental protection treatment facilities such as waste water and waste gas of Jinxi Pharmaceutical Factory, and issued a completion acceptance monitoring report of environmental protection facilities at the end of August.

2020

07-31

Jinxi plant environmental protection facilities through the completion of acceptance

2020

07-31

Jinxi plant environmental protection facilities through the completion of acceptance

2020

07-30

Daye Jianfeng Safety Standard was awarded as the only award-winning enterprise in daye city in 2015.

Due to the achievements made in the establishment of secondary safety production standardization, daye peak cement company recently received a special award of 200000 yuan from daye municipal government. In order to encourage industrial and commercial enterprises in the region to improve their production safety, daye municipal government set up a special fund in 2015, stipulating that 200000 yuan will be awarded to those who pass the secondary safety standardization review before December 31, 2015. It is understood that among the industrial and commercial enterprises in daye city, there were 4 enterprises that applied for and passed the examination in 2015, but only daye peak passed the examination before December. Therefore, Daye Peak has become the only enterprise that has won the special award for the establishment of the safety standard in Daye City in 2015. (Ye Meifang)

2020

07-31

Two Cement Enterprises Start to Implement "Big Patrol Inspection"

With the change of the competition situation in the industry, the profit space of cement production enterprises has been greatly squeezed. Reducing costs and increasing efficiency and job optimization have become the inevitable choice to improve the enterprise's own development ability and enhance the core competitiveness. In accordance with the requirements of the group company to realize the transformation from extensive management to lean management, combined with the advanced experience of peer enterprises, recently, Yunnan peak, daye peak two enterprises have implemented "big inspection" to promote the overall optimization of posts. On November 1, daye peak post inspection officially started full operation, starting from the limestone storage yard at the source of the production line to the cement storage. the original 15 posts were merged, and the best experienced mechanics, electricians and post workers were transferred to form a large inspection class, which was mainly responsible for on-site emergency disposal and post routine maintenance to ensure the normal production of the whole production line. In order to ensure the smooth implementation of the large-scale inspection, daye peak management team has repeatedly communicated and discussed with the heads of relevant workshops and departments, and held a special workshop post optimization promotion meeting in September to clarify objectives and responsibilities, formulate implementation steps, and do a lot of preparatory work. At the kick-off meeting for the implementation of the large-scale inspection on October 31, Zhang Fengliang asked daye peak employees to recognize the current situation of serious cement overcapacity and cruel market competition, understand the necessity of implementing the large-scale inspection, and asked the workshop leaders to do a good job in training and guiding the employees, shorten the transition period, normalize the operation of the large-scale inspection as soon as possible, and at the same time, managers should also change their working ideas and concepts and do a good job in full-time, strengthen the inspection, overhaul and maintenance of the regular day shift, and find and solve the problems existing in the equipment and process in time.

2020

07-30

< 1...53 54 55...61 > 跳转到页